AS568 · ISO 3601 · MIL-PRF cross-references, 15 compounds
Standards · AS568

What AS568 actually specifies

AS568 is a size standard, not a material standard. It fixes the inside diameter and cross-section of 369 o-ring sizes and gives each one a dash number. It says nothing about what the rubber is made of — that is a separate callout, and it is the one that decides whether the seal works.

01The structure

369 dash numbers, split into six series. The first digit of a three-digit dash is the series, and the series is determined by the cross-section, not by the diameter. -214 and -114 are both nominally one inch bore, but one is 0.139 in thick and the other 0.103 in — they do not interchange and they do not share a groove.

SeriesDash rangeSizes Cross-sectionID range (mm)
000 series-001 … -050500.040 in0.74 … 133.07 mm
100 series-102 … -178770.103 in1.24 … 247.32 mm
200 series-201 … -284840.139 in4.34 … 456.06 mm
300 series-309 … -395870.210 in10.46 … 658.88 mm
400 series-425 … -475510.275 in113.66 … 658.88 mm
900 series-901 … -932200.056 in4.7 … 59.36 mm

The 900 series is a separate callout: boss gaskets for straight-thread tube ports, with their own cross-sections and their own groove dimensions. They are not interchangeable with the 0xx to 4xx rings even where the inside diameter looks close.

02Nominal size versus actual size

The fraction printed next to a dash number is a name, not a dimension. AS568-214 is called "1 inch by 1/8 inch" and measures 0.984 × 0.139 in. AS568-325 is called "1-1/2 by 3/16" and measures 1.475 × 0.210 in. Order by the dash number or by the actual dimensions — never by the nominal fraction.

Why the difference exists

The nominal name comes from the groove and tube sizes the ring was designed for. The actual dimension is what a mould produces after the standard's tolerance band is applied. Both are correct; they are answers to different questions.

03What the standard does not cover

Compound

Nothing in AS568 says NBR, FKM or EPDM. A dash number can be moulded in any of the fifteen compounds on this site, and the choice is governed by the medium and the temperature.

Tolerances by class

AS568 gives tolerance bands, but which band applies depends on the callout and the application. The bands on our size pages are typical commercial values — the drawing governs.

Quality requirements

Surface defects, flash limits and inspection levels come from a separate specification such as ISO 3601-3 or the customer's drawing, not from the size standard.

Groove design

The groove is designed from the cross-section and the squeeze percentage, not from the dash number. Two sizes in the same series share a groove depth but not a groove width.

04The data on this site

Size data from the AS568 chart, 369 dash numbers, digitised and checked against four independent sources. Military designations are compiled from public catalogue data — confirm against the current ASSIST record before design control.

The whole table is downloadable as CSV — 369 rows with dash number, series, nominal fractions, ID, CS and OD in both unit systems, plus typical tolerance bands. No registration, no email capture.

as568-sizes.csv