01Worked examples
Look at -210 and -310. Both end in 10, both are nominally one inch bore. The 200 series is 0.139 in thick, the 300 series is 0.210 in. The number inside the series counts up in steps that widen as the diameter grows — 1/32 in at the small end of a series, 1/4 in at the large end.
02What people get wrong
Dropping a leading zero
-010, -110, -210 and -310 are four different parts. Write all three digits, including the zeros, or you will be quoted the wrong cross-section.
Reading it as a diameter
The digits after the series are a sequence number, not a size. -250 is not 2.50 in anything: it is 3.859 in inside diameter.
Assuming a mil number is the same part
MS28775-214 adds a material callout to the -214 geometry. Same size, different specification, not automatically interchangeable.
Using metric numbers in the same field
A metric size such as 25 × 3.5 is not a dash number. Do not put it where a dash number is expected — a supplier's order entry will either reject it or misread it.
03From a mil-spec number back to the size
Strip the document prefix and any variant suffix. The last group of digits is the dash number. M83248/1-214 is the -214 size in fluorocarbon; MS29513-110 is the -110 size in a fuel-resistant nitrile. The size never lives in the prefix.
The reverse is not true: a dash number does not tell you which compound, so it cannot tell you which military designation applies. That is why our size pages list every designation on record for the dash, with the status of each.