01Dimensions
inch values are normative · mm converted at 25.4Section through the ring: one dash number fixes all three dimensions at once.
| Inside diameternominal, not actual | 0.029 | in |
|---|---|---|
| Cross-sectionnominal | 0.040 | in |
| Outside diametercalculated, ID + 2 × CS | 0.109 | in |
| ID tolerancetypical commercial band | ±0.005 | in |
| CS tolerancetypical commercial band | ±0.002 | in |
| Inside diameter | 0.74 | mm |
|---|---|---|
| Cross-section | 1.02 | mm |
| Outside diameter | 2.77 | mm |
| ID tolerance | ±0.13 | mm |
| CS tolerance | ±0.05 | mm |
Tolerance bands are typical commercial values for this cross-section. Where the drawing calls out a tighter or wider band, the drawing governs and we quote to it.
02Military cross-reference
compiled from public catalogue dataAS568-001 is a standard commercial size, but no MIL-PRF or MS document in our data set calls it out. If your drawing cites one we do not have, send the number — we will trace it and add it.
03Available compounds
same tool, 15 materialsEvery compound below is moulded in the AS568-001 tool, so the dimensions do not change when you change material. Temperature bands are the continuous service range for the standard formulation.
04Questions we get on this size
What is AS568-001 in millimetres?
0.74 mm inside diameter × 1.02 mm cross-section, outside diameter 2.77 mm. These are converted from the inch values at 25.4 and rounded to two decimals — a metric drawing will normally specify a different, rounder size.
The closest AS568 size is -002 at 0.042 in (1.07 mm), which is 0.33 mm away on the inside diameter.
What is the outside diameter?
0.109 in (2.77 mm), calculated as ID + 2 × CS. This is the free, uninstalled diameter. Installed in a groove the ring stretches slightly and the OD you measure on the part will not match this number.
Is a mil-spec number for this size the same part?
Same geometry, different material specification. A designator such as MS28775-001 fixes the compound as well as the size. If you substitute a different compound for the same dash number the part will fit, but its swell in the medium and its compression set at temperature will differ — which is what the material callout was there to control.
Can you make it in FFKM or another special compound?
Yes, to order. FFKM and the perfluoroelastomers are compression moulded for this size rather than transfer moulded, so tooling cost applies and lead time is around four weeks. It is normally only worth it above 200 °C or in solvents that swell FKM.
05Other sizes in this cross-section
0.040 in · 000 seriesA groove cut for one 0.040 in section takes any of these. Change the ID without changing the groove depth.